Epson Stylus Pro 10000 Product Support Bulletin page 90

6. When loading paper, ensure that the right edge of the paper lines up to the left edge of the vertical
alignment holes on the lower paper guide of the printer. Loading the paper to the right of the holes may
cause a slight margin on the edge of the page.
Hardware settings/adjustments for Borderless Printing:
1. Ensure the printer is in a Ready mode and press the SelecType button. The LCD display will show Printer
Setup.
2. Press the SelecType button once more to enter the Printer Setup Menu.
3. Press the down button until the display shows No Margin. Press the SelecType button to enter the No
Margin menu.
4. Press the up or down buttons to select one of the three types of No Margin printing options.
NOTE: When not selecting No Margin in the Epson driver or using a Fiery Spark or a 3
these settings do not make any difference to "normal" printing.
L/R only - Enables no margin on the left and right side of the page only.
i. Select this mode for use with cut sheet media, when using the optional Auto Take-up reel
1 CUT – Media saver mode:
i. Each image is butted up against the next, bottom to top and 1 cut separates them. In this
2 CUT – Best Quality Mode:
i. A small amount of media is fed between each print. The printer will cut the border of each
Whether using the 1 Cut or 2 Cut method, there will always be a small amount of media wasted
on the leading edge of the print job. This is to allow media to be dropped out of the printer when
the leading edge is cut since the printer cannot print on the leading edge of the media.
5. Once you've selected one of the 3 methods above, press the Enter button to set the value (designated by
an asterisks *).
6. Press the Paper Source button to move back to the Printer Setup menu and press the down button to
move to Cut Adj.
7. Press the SelecType button once to enter the Cut Adj. mode and press Enter to execute the adjustment.
8. The printer will print an alignment pattern (labeled 1-17) and then cut down the center of the pattern (Light
Black and Magenta).
9. Looking at the cut pattern, you want to select the value (using the up or down button) that has the cut
closest to the center mark and press the Enter button to set that value (as noted by an asterisks*). This
adjustment may be very useful when using the 1 cut method so that no data from one image imposes on
the other print.
10. Press the Paper Source button until the printer is back to a Ready mode.
Page 2
(SP9600 only) and media which does not support the internal cutter. The top and bottom
edges will require manual trimming.
mode the Cut Adjust described (item 6) is extremely important. An inaccurate cut may
leave some printed data that will show on one of the prints. Media with a high curl memory
should not use this mode as the cut may be slightly inaccurate regardless of adjustment.
On a single image job the next job will still have a leading edge (which will be cut
automatically), as the printer cannot print at the very edge of the media.
print independently with no overlap of image data.
rd
party RIP