Epson Stylus Pro 10000 Product Support Bulletin page 42

Hardware settings/adjustments for Borderless Printing:
1. Ensure the printer is in a Ready mode and press the SelecType button. The LCD display will show
Printer Setup.
2. Press the SelecType button once more to enter the Printer Setup Menu.
3. Press the down button until the display shows No Margin. Press the SelecType button to enter the
No Margin menu.
4. Press the up or down buttons to select one of the three types of No Margin printing options.
NOTE: When not selecting no margin in the Epson driver or using a Fiery Spark or a 3
these settings do not make any difference to "normal" printing.
•
L/R only - Enables no margin on the left and right side of the page only.
i. Select this mode for use with cut sheet media, when using the optional Auto Take-
•
1 CUT – Media saver mode:
i. Each image is butted up against the next, bottom to top and 1 cut separates them.
•
2 CUT – Best Quality Mode:
i. A small amount of media is fed between each print. The printer will cut the border
•
Whether using the 1 Cut or 2 Cut method, there will always be a small amount of media
wasted on the leading edge of the print job.
5. Once you've selected one of the 3 methods above, press the Enter button to set the value
(designated by an asterisks *).
6. Press the Paper Source button to move back to the Printer Setup menu and press the down
button to move to Cut Adj.
7. Press the SelecType button once to enter the Cut Adj. mode and press Enter to execute the
adjustment.
8. The printer will print an alignment pattern (labeled 1-17) and then cut down the center of the
pattern (Light Black and Magenta).
9. Looking at the cut pattern, you want to select the value (using the up or down button) that has the
cut closest to the center mark and press the Enter button to set that value (as noted by an
asterisks*). This adjustment may be very useful when using the 1 cut method so that no data from
one image imposes on the other print.
10. Press the Paper Source button until the printer is back to a Ready mode.
Page 2 of 4
up reel (SP9600 only), and media which does not support the internal cutter. The
top and bottom edges will require manual trimming.
In this mode the Cut Adjust described (item 6) is extremely important. An
inaccurate cut may leave some printed data that will show on one of the prints.
Media with a high curl memory should not use this mode as the cut may be slightly
inaccurate regardless of adjustment. On a single image job the next job will still
have a leading edge (which will be cut automatically) as the printer cannot print at
the very edge of the media.
of each print independently with no overlap of image data.
rd
party RIP