Printout Is Garbled; Graphics Do Not Print Correctly - Epson AcuLaser C9100 Reference Manual

Printout is garbled

Cause
The interface cable may not be
plugged in securely.
You may not be using the
correct interface cable.
The emulation setting for the
port may not be correct.
Note:
If a status sheet does not print correctly, your printer may be damaged. Contact
your dealer or a qualified service representative.

Graphics do not print correctly

Cause
The printer emulation setting
in your application may be
incorrect.
You may need more memory. Graphics require large amounts of
280
Troubleshooting
What to do
Make sure that both ends of the interface
cable are plugged in securely.
If you are using the parallel interface,
make sure that the cable is a
double-shielded, twisted-pair interface
cable no more than six feet in length.
If you are using the USB interface, use a
Revision 2.0 cable.
Specify the emulation mode by using the
printer's control panel menus. See
"Emulation Menu" on page 347.
What to do
Make sure that your application is set for
the printer emulation you are using. For
example, if you are using the LJ4
emulation mode, make sure that your
application is set to use a LaserJet 4
printer.
memory. Install an appropriate memory
module. See "Memory Module" on page
213.