Configuring Command-Line Access - Cisco 887V - Integrated Services Router Software Configuration Manual

Chapter 3 Basic Router Configuration
•
After you have collected the appropriate information, you can perform a full configuration on your
router, beginning with the tasks in the
To obtain or change software licenses:
•

Configuring Command-Line Access

To configure parameters to control access to the router perform these steps, beginning in global
configuration mode:
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
DETAILED STEPS
Command
Step 1 line [aux | console | tty | vty] line-number
Example:
Router(config)# line console 0
Router(config-line)#
Step 2 password password
Example:
Router(config)# password 5dr4Hepw3
Router(config-line)#
Step 3 login
Example:
Router(config-line)# login
Router(config-line)#
OL-22206-01
If you plan to connect over an ADSL or G.SHDSL line:
Order the appropriate line from your public telephone service provider.
–
For ADSL lines—Ensure that the ADSL signaling type is DMT (also known as ANSI T1.413)
or DMT Issue 2.
For G.SHDSL lines—Verify that the G.SHDSL line conforms to the ITU G.991.2 standard and
supports Annex A (North America) or Annex B (Europe).
See Software Activation on Cisco Integrated Services Routers and Cisco Integrated Service Routers
G2
line [aux | console | tty | vty] line-number
password password
login
exec-timeout minutes [seconds]
line [aux | console | tty | vty] line-number
password password
login
end
Cisco 880 Series Integrated Services Router Software Configuration Guide
"Configuring Command-Line Access" section on page
Purpose
Enters line configuration mode, and specifies the
type of line.
This example specifies a console terminal for
access.
Specifies a unique password for the console
terminal line.
Enables password checking at terminal session
login.
Configuring Command-Line Access
3-5.
3-5