Cisco 887V - Integrated Services Router Software Configuration Manual page 32

Configuring WAN Interfaces
Configuring the ATM CPE SIDE
Perform the following steps to configure the ATM CPE side, starting in global configuration mode.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
DETAILED STEPS
Step 1
Step 2
Step 3
Step 4
Step 5
Cisco 880 Series Integrated Services Router Software Configuration Guide
3-12
interface type number
no shutdown
interface atm0.1 point-to-point
ip address ip-address mask
ppvc [name] vpi/vci
protocol protocol {protocol-address [virtual-template] | inarp} [[no] broadcast |
disable-check-subnet | [no] enable-check-subnet]
end
Command
interface type number
Example:
Router (config) # interface atm0
no shutdown
Example:
Router (config-if) # no
shutdown
Router (config-if) #
interface atm0.1 point-to-point
Example:
Router (config-if) # interface
ATM0.1
point-to-point
Router (config-subif) #
ip address ip-address mask
Example:
Router (config-subif)# ip address
30.0.0.1 255.255.255.0
pvc [name] vpi/vci
Example:
Router (config-subif) # pvc 13/32
Router (config-if-atm-vc) #
Chapter 3 Basic Router Configuration
Purpose
Enters configuration mode for the ATM
WAN interface (ATM0).
Enables the configuration changes to
the ATM interface.
Enables the ATM0.1 point-to-point
interface.
Enters IP address and subnet mask.
Creates or assigns a name to an ATM
PVC and enters the ATM virtual circuit
configuration mode.
OL-22206-01