Detailed Steps; Command; Step 1; Example - Cisco 887V - Integrated Services Router Software Configuration Manual

Starting a Wireless Configuration Session
Starting a Wireless Configuration Session
Note
Enter the following commands in global configuration mode on the router's Cisco IOS CLI.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
DETAILED STEPSf

Command

Step 1

interface wlan-ap0

Example:

router(config)# interface wlan-ap0
router(config-if)#
Step 2 ip address subnet mask
Example:
router(config-if)# ip address
10.21.0.20 255.255.255.0
or
router(config-if)# ip unnumbered vlan1
Step 3 no shutdown
Example:
router(config-if)# no shutdown
Cisco 880 Series Integrated Services Router Software Configuration Guide
4-2
Before you configure the wireless settings in the router's setup, you must follow these steps to
open a session between the router and the access point.
interface wlan-ap0
ip address subnet mask
no shutdown
interface vlan1
ip address subnet mask
exit
exit
service-module wlan-ap 0 session
Chapter 4 Basic Wireless Device Configuration
Purpose
Defines the router's console interface to the wireless
device. The interface is used for communication
between the router's console and the wireless device.
Always use port 0.
The following message appears:
The wlan-ap 0 interface is used for managing
the embedded AP. Please use the service-module
wlan-ap 0 session command to console into the
embedded AP.
Specifies the interface IP address and subnet mask.
The IP address can be shared with the IP
Note
address assigned to the Cisco Integrated
Services Router by using the ip unnumbered
vlan1 command.
Specifies that the internal interface connection will
remain open.
OL-22206-01