Cisco 887V - Integrated Services Router Software Configuration Manual page 26

Configuring Command-Line Access
Command
Step 4 exec-timeout minutes [seconds]
Example:
Router(config-line)# exec-timeout 5 30
Router(config-line)#
Step 5 line [aux | console | tty | vty] line-number
Example:
Router(config-line)# line vty 0 4
Router(config-line)#
Step 6 password password
Example:
Router(config-line)# password aldf2ad1
Router(config-line)#
Step 7 login
Example:
Router(config-line)# login
Router(config-line)#
Step 8 end
Example:
Router(config-line)# end
Router#
Example
The following configuration shows the command-line access commands.
You do not need to input the commands marked "default." These commands appear automatically in the
configuration file generated when you use the show running-config command.
!
line con 0
exec-timeout 10 0
password 4youreyesonly
login
transport input none (default)
stopbits 1 (default)
line vty 0 4
password secret
login
!
Cisco 880 Series Integrated Services Router Software Configuration Guide
3-6
Chapter 3
Purpose
Sets the interval that the EXEC command
interpreter waits until user input is detected. The
default is 10 minutes. Optionally, add seconds to
the interval value.
This example shows a timeout of 5 minutes and
30 seconds. Entering a timeout of 0 0 specifies
never to time out.
Specifies a virtual terminal for remote console
access.
Specifies a unique password for the virtual
terminal line.
Enables password checking at the virtual terminal
session login.
Exits line configuration mode, and returns to
privileged EXEC mode.
Basic Router Configuration
OL-22206-01