To Start And Stop The Product; To Operate The Product; Transportation; Storage - Meec tools 027121 Operating Instructions Manual

4.4 To start and stop the product

1
Push and hold the lock-out button with your thumb
and then push the on/off trigger with your fingers.
2
Release the lock-out button when the product starts.
3
To stop the product, release the on/off trigger.

4.5 To operate the product

● Push the product forward slow enough to clear the path
completely.
Note! The applicable forward speed depends on the snow
depth.
● Hold the product by the main handle and the auxiliary
handle when clearing deeper drifts.
5

Transportation

● Stop the product and remove the battery before
transportation.
6

Storage

● Remove the battery before the product is stored.
● Clean the product thoroughly with a soft brush or cloth
before it is stored. Remove any dirt, especially on the
motor vents.
8

Troubleshooting

Warning! If you cannot identify och correct a problem yourself, refer to an authorized service center.
Problem
The product does not start.
The motor starts, but the blade does not
move.
The product vibrates abnormally.
● Make sure that all connections are tightened.
● Examine the moving parts for damage, breakage, and
wear. Refer to an authorized service center if there are
any damaged or missing parts.
● Store the product in a safe and dry place out of the reach
of children.
● Do not store the product near corrosive materials such as
deicing salt or fertilizers.
7
let the product come to a complete stop before any mainte-
nance is done to it.
7.1
product!
● Keep all safety devices, air vents and the motor housing
free from dirt and dust as far as possible.
● Clean the product with a cloth or blow it with
compressed air at low pressure after each use.
Possible cause
The battery is discharged.
The lock-out button or the on/off trigger
is not pushed.
The drive belt is loose, worn or
damaged.
Some part of the product is worn or
damaged.

Maintenance

Warning! Stop the product, remove the battery and

To clean the product

Warning! Make sure that no water comes into the
Charge the battery.
Refer to "4.4 To start and stop the
product" on page 9.
Refer to an authorized service center
to have the drive belt replaced.
Refer to an authorized service
center.
Action
9