Diode Dynamics Stage CrossLink SS5 Manual

Thank you for your purchase of our new SS5 CrossLink or SS50
Windshield Lightbar Kit. CAD-designed to use existing mounting points,
this kit is compatible with the 2007-2018 Jeep JK Wrangler.
Installation instructions are included below.
Please contact us if you have any questions.
Tools Needed: T40 torx bit and ratchet
PAGE 1
Windshield Lightbar Kit
1. On the driver's side a-pillar, remove the six
bolts shown in the picture to the left using a
T40 Torx bit and ratchet.
Five will be reused.
2. Align the holes on the protecting pad with the
mounting holes on the bracket. Before securing
the bracket and mounting pad to the vehicle,
route your wiring harness behind the bracket
as shown in the pictures to the left.
(314) 205-3033
Jeep JK Wrangler
See back for further instructions.
WWW.DIODEDYNAMICS.COM