FireAngel Multisensor Plus Operating Instructions Manual

Multifunctional radio, smoke, heat & carbon monoxide detector

Hide thumbs

Table Of Contents

Quick Links

Download this manual

OPERATING INSTRUCTIONS

for residents

Fire in the flat

Fire in the house

Carbon monoxide in the home

Table of Contents

Need help?

Do you have a question about the Multisensor Plus and is the answer not in the manual?

Questions and answers

Summary of Contents for FireAngel Multisensor Plus

Page 1 OPERATING INSTRUCTIONS for residents Fire in the flat Fire in the house Carbon monoxide in the home...
Page 3: Table Of Contents
Table of Contents Declaration of conformity ......Manufacturer ........Product overview .
Page 4: Declaration Of Conformity
Declaration of conformity Multifunctional wireless smoke alarm device „Multisensor Plus“ and „Multisensor Plus Kitchen“ By affixing the CE mark to this product, the manufacturer assumes responsibility for compliance with all applicable European health, safety, performance and environmental requirements. The complete part of the EU Declaration of Conformity is available at the following internet address: https://www.techem.com/de/de/info-und-service/downloads...
Page 5: Product Overview
Product overview OPERATING INSTRUCTIONS...
Page 6 „ Troubleshooting“ green Power LED Ì Indicates that the device is ready for operation Signal transmitter out- Ì Emits warning tones during an alarm and signal tones during malfunctions put/ acoustic opening No built-in camera/no built-in microphone MULTISENSOR PLUS...
Page 7: Indicators And Controls
Ì Press the user button for approx. 3 seconds Green: Detector is OK Function Ì Warning tone: Function Check by Warning tone Yellow: Detector detects a Multisensor Plus is OK check the user malfunction Ì No warning tone: refer to troubleshooting OPERATING INSTRUCTIONS...
Page 8: General Information
General information Smoke, heat, and carbon monoxide alarms are critical life-sa- The Multisensor Plus is an advanced smoke alarm that pro- ving devices. Legislation mandates that residential properties vides additional functionalities beyond standard models. It must install smoke alarms in escape routes and sleeping detects smoke, heat, and carbon monoxide (CO), issuing spe- areas.
Page 9: Grouping
The smoke, heat, and carbon monoxide detection sensors are worked devices will also be silenced after a short delay. If the only active when the Multisensor Plus is mounted on the ins- button is pressed on a device that did not detect the alarm, tallation plate.
Page 10: Safety Instructions
Devices with the kitchen stove symbol cannot detect Ì The use of the Multisensor Plus is not a substitute for smoke and are therefore exclusively suitable for use in proper electrical installation, use, and maintenance of the kitchen (Item No.: 580250).
Page 11: Fire Safety Guidelines
Ì Only use electrical devices and tools that carry a recogni- DANGER zed approval mark. If the cause of an alarm is in question, it should be Ì Place keys for apartment and front doors within easy assumed that the alarm is due to an actual fire or reach for all residents, ensuring access to exits even elevated CO concentration, and the premises should be evacuated immediately.
Page 12: Carbon Monoxide (Co)- Important Guidelines
Ì Gather: Meet with other residents outside the building and check that everyone is present. Ì Re-entry: NEVER re-enter a smoke-filled or burning apartment. Ì Key Handover: Give your apartment keys to the fire department. MULTISENSOR PLUS...
Page 13 The CO detector monitors the CO concentration in parts per Ì This device is designed to protect individuals from the million (ppm) in the air around the detector. acute effects of carbon monoxide exposure. It may not 50 ppm protect those who are at additional risk due to age, Ì...
Page 14: Function Check And Cleaning
Ì Gather with other residents outside the building and Function check check that everyone is present. The Multisensor Plus automatically checks its battery capa- Ì Contact the responsible authorities or services (e.g., city, functions, sensors, and the proximity of any obstructi- chimney sweep) to address the issue.
Page 15 When Techem is commissioned with the RWM service plus, Additionally, during the inspection, ensure that: malfunctions are promptly identified by Techem and reme- Ì the casing is undamaged, dust-free, and not dirty, diation is initiated, even if you do not notice or report them Ì...
Page 16: Cleaning
Never spray the device directly. If necessary, the surface To remove the Multisensor Plus, turn it counterclockwise of the Multisensor Plus can be gently wiped with a slightly (to the left) by hand and pull it down from the mounting plate.
Page 17: Reassembly
The Multisensor Plus Kitchen must be reassembled in should therefore always be taken seriously. the kitchen. 2. Each Multisensor Plus must be reassembled in its origi- If you cannot detect any smoke or fire source, it could nal room on the mounting plate. For better identification, be the colorless and odorless gas carbon monoxide (CO).
Page 18: Common Causes Of False Alarms
The Multisensor Plus signals malfunctions with the yellow fault LED and with sound signals. If malfunctions occur in the Multisensor Plus or if the battery voltage is too low, for Common causes of false alarms include: safety reasons, doors to rooms with functioning smoke de- Ì...
Page 19 Severe functional disruptions of the Multisensor Plus cannot be fixed by the user. Do not attempt to repair defective Multisensor Plus devi- ces, as this is not possible and can lead to electric shock or malfunction. A persistent device defect requires professio- nal replacement by Techem.
Page 20: Distance Control
Distance control Fire smoke must be able to reach the Multisensor Plus unobstructed. Normally, obstacles and objects should be at least 50 cm away from the device. Obstacles and ≥ 50 cm ≥ 50 cm furnishings added later that are closer than this distan- ce are detected and signaled as a disturbance by the Multisensor Plus.
Page 21 If it is not possible to mount the Multisensor Plus on the cei- ling, an alternative is to install it on the wall. For wall moun- ting, a consistent clearance of at least 50 cm around the device and into the room is required.
Page 22: Configuration Of Room Climate Data And Ventilation Advice
Note: When the Multisensor Plus is initially set up, climate data trans- climate. To use a climate service app, it is necessary to activate the fer is disabled by default on the device.
Page 23: Activating The Ventilation Advice Led (On/Off) For The Ventilation Advice
Activating the ventilation advice LED (on/off) for the ventilation advice: NOTE: The Multisensor Plus features a ventilation advice LED display for venti- Ì For product description, see page 5. Ì lation advice. It provides guidance to help you achieve an optimal indoor Further details on the next page.
Page 24 The Multisensor Plus measures relative humidity and room You can access the ventilation advice configuration by dou- temperature with sensors. The device uses these readings ble-clicking the user button again. Here, you can choose to signal if there is prolonged excessive relative humidity. An...
Page 25: Technical Data
Technical data Version Multisensor Plus Multisensor Plus Kitchen Type Techem Smart System remote inspec- Techem Smart System remote inspec- table alarm Type C, in accordance with table alarm Type C DIN 14676-1 Sensors Ì Smoke detection: Ì Heat detection: Photo-optical scattered light method Thermistor (Class A1)
Page 26 Version Multisensor Plus Multisensor Plus Kitchen Maximum service life 10 Jahre (+ 6 months) Power supply Ì Permanently installed non-replaceable long-life lithium battery Ì Battery life: 10 years + 1 year reserve Compliance EN 14604 2005 + AC 2008 (CE); EN 50291-1 2018;...
Page 27 FAQs, the user manual in other languages as a PDF , and addi- tional information can be found via the QR code on the device or at Multisensor Plus Functions of the Device Variants Multisensor Plus Multisensor Plus Kitchen Attic...
Page 28 Any violation of this requirement may result in legal action and will be prosecuted if necessary. All rights reserved. Techem Energy Services GmbH Hauptstraße 89 · D-65760 Eschborn · www.techem.de This product is manufactured by FireAngel Safety Technology Limited and imported to EU by FireAngel Safety Technology Europe B.V. . Assembled in China...

This manual is also suitable for:

Multisensor plus kitchen 580200 580250