FireAngel Multisensor Plus Operating Instructions Manual page 15

When Techem is commissioned with the RWM service plus,
malfunctions are promptly identified by Techem and reme-
diation is initiated, even if you do not notice or report them
yourself.
In addition to automatic function checks, the device manu-
facturer recommends conducting a manual function check at
least once a year to familiarize yourself with the device and
its signals.
To do this, press the user button on the front of the
device until a beep sounds.
Never use an open flame, smoke, or any
other similar means to test the device.
OPERATING INSTRUCTIONS
CAUTION
Additionally, during the inspection, ensure that:
Ì the casing is undamaged, dust-free, and not dirty,
Ì fire smoke can reach the device unhindered,
Ì no fluorescent tubes, fireplaces, fans, or ventilation systems
have been installed near the device after its initial setup.
Please contact the hotline at 0800 2001264 (toll-free)
as soon as possible if:
Ì no beep sounds when pressing the user button for more
than 5 sec.
Ì any deviations from the points mentioned above occur.
A functional test does not trigger a signal tone for all grouped
devices. Each device must be tested individually.
If neither Techem nor another service provider has been com-
missioned to perform the mandatory annual functional check
as per the German Institute for Standardization (DIN), it must
be carried out manually by you or your landlord.
-
15