Dakota Digital LED Tail Lights LAT-NR350 Installation Instructions

Led tail lights for 1964-1966 mustang

Download this manual

MAN#650204

Kit Includes:

Installation:

1. Remove both right and left tail light lenses as described below at the same time, taking care to

keep the left and right lenses and trim with the correct side of the vehicle.

2. Remove the four screws that hold the chrome tail light trim piece.

3. Remove the tail light trim piece and the lens.

4. Remove the light bulb from socket.

5. Loosen the lens seal from the housing by gently pulling the seal away from the housing.

6. Now is a good time to clean the lenses and the tail light housings. If the lenses are in poor

condition a replacement set is recommended.

7. Make sure the housings and lenses are clean and dry. DO NOT remove backing from tape yet!

Place the light diffuser onto the back of the lens. Check for proper fitment of diffuser to inside

of lens and note the places where the tape touches the lens.

INSTALLATION INSTRUCTIONS

LAT-NR350

LED Tail Lights for 1964-1966 Mustang

MAN#650204

Page 1 MAN#650204 Kit Includes: Installation: 1. Remove both right and left tail light lenses as described below at the same time, taking care to keep the left and right lenses and trim with the correct side of the vehicle. 2. Remove the four screws that hold the chrome tail light trim piece. 3.
Page 2 8. DO NOT remove the backing from the tape yet! Place the LED assembly in the housing. The wide black bar on the wire side of the LED assembly is marked to show which end of the assembly should be up. Note the places where the tape touches the housing. 9.
Page 3 This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.