Dakota Digital LED Tail Lights for 1969 Camaro LAT-NR111 Installation Instructions

Led tail lights for 1969 camaro

Download this manual

MAN#650170

Kit Includes:

Installation:

1. Remove the original bulb connectors from the bottom side of the housing.

2. Remove the plastic housing from the vehicle.

3. Remove the tail light lens by gently prying the housing away from the lens tabs.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is

recommended.

5. Note that the screws and mounting plates are assembled differently for the driver side set and

passenger side set. The LED assemblies will sit in the housing at an angle similar to the back

side of the original lens.

driver side(screws and mounting plate offset to the left)

passenger side(screws and mounting plate offset to the right)

INSTALLATION INSTRUCTIONS

LAT-NR111

LED Tail Lights for 1969 Camaro

MAN#650170

Page 1 MAN#650170 Kit Includes: Installation: 1. Remove the original bulb connectors from the bottom side of the housing. 2. Remove the plastic housing from the vehicle. 3. Remove the tail light lens by gently prying the housing away from the lens tabs. 4.
Page 2 6. Insert each new LED assembly through the hole where the original bulb and connector were located. Use caution when feeding the wires through the socket opening to avoid damaging the wire insulation. 7. Feed the wires through the large hole in the back plate and attach the back plate onto the back side of the housing.
Page 3 This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.