Dakota Digital LED Tail Lights for 1969 Chevelle LAT-NR310 Installation Instructions

Led tail lights for 1969 chevelle

Download this manual

MAN#650207

Kit includes:

Installation:

1. Remove the tail light housing from the vehicle.

2. Remove the bulb connector from the back of the housing.

3. Remove the 4 screws that hold the trim and lens. Remove the trim and tail light lens from the

tail light housing.

4. Now is a good time to clean or replace the lens and housing if necessary.

5. Note that there are two different LED assemblies. One for the driver side and one for the

passenger side. Select the correct assembly for the tail light housing. Remove the two locking

nuts and flat aluminum plate from the back of the new LED assembly.

Left or driver's

side LED assembly.

INSTALLATION INSTRUCTIONS

LAT-NR310

LED Tail Lights for 1969 Chevelle

Right or passenger's

side LED assembly.

Page 1 MAN#650207 Kit includes: Installation: 1. Remove the tail light housing from the vehicle. 2. Remove the bulb connector from the back of the housing. 3. Remove the 4 screws that hold the trim and lens. Remove the trim and tail light lens from the tail light housing.
Page 2 6. Insert each new LED assembly through the hole where the original bulb and connector were. Use caution when feeding the wires through to avoid damaging the wire insulation. 7. Feed the wires through the large hole in the back plate and attach the back plate onto the back side of the housing.
Page 3 This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.