Dakota Digital LED Tail Lights for 1970 Chevelle LAT-NR320 Installation Instructions

Led tail lights for 1970 chevelle

MAN#650202

Kit Includes:

1. Remove the tail light lenses. There are four screws holding each lens in.

2. Remove the tail light bulbs.

3. We recommended that the lens and housings be cleaned to insure proper mounting and

visibility of the LED assembly. If the lenses are in bad shape a new set is suggested.

4. DO NOT remove the tape from the led assemblies yet!

5. Test fit the assembly into the lens as shown below to make sure it aligns correctly.

6. Make sure you have BOTH lenses clean and dry so the single use primer applicator can be

used for both lenses. Apply the primer to the top and bottom edges of the lens where the tape

will attach. AFTER THE PRIMER HAS BEEN APPLIED, LET THE LENS DRY FOR 5

MINUTES BEFORE GOING ON.

INSTALLATION INSTRUCTIONS

LAT-NR320

LED Tail Lights for 1970 Chevelle

MAN#650202

Table of Contents

Do you have a question about the LED Tail Lights for 1970 Chevelle LAT-NR320 and is the answer not in the manual?

Page 1 MAN#650202 Kit Includes: Installation: 1. Remove the tail light lenses. There are four screws holding each lens in. 2. Remove the tail light bulbs. 3. We recommended that the lens and housings be cleaned to insure proper mounting and visibility of the LED assembly. If the lenses are in bad shape a new set is suggested. 4.
Page 2 This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.