Dakota Digital LED Tail Lights LAT-NR340 Installation Instructions

Led tail lights for ’73-’87 chevy fleetside pickup and ’87-’91 suburban/blazer

MAN#650203

Kit Includes:

1. Remove the tail light lenses. There are four screws holding each lens in place.

2. Remove the light bulbs.

3. Now is a good time to clean the lenses and housings. If lenses are in bad shape a new set is

recommended.

4. DO NOT remove the tape from the LED assemblies yet!

INSTALLATION INSTRUCTIONS

LAT-NR340

LED Tail Lights for '73-'87 Chevy Fleetside Pickup

and '87-'91 Suburban/Blazer

MAN#650203

Table of Contents

Do you have a question about the LED Tail Lights LAT-NR340 and is the answer not in the manual?

Page 1 MAN#650203 Kit Includes: Installation: 1. Remove the tail light lenses. There are four screws holding each lens in place. 2. Remove the light bulbs. 3. Now is a good time to clean the lenses and housings. If lenses are in bad shape a new set is recommended.
Page 2 5. Test fit the assembly into the tail light housing as shown below to make sure it aligns correctly. 6. Before mounting the new LED assembly into the housing, plug the bulb base into the stock bulb socket and test the tail lights and flashers to make sure everything is working correctly. 7.
Page 3 This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.