Reboot And Restore; Firmware Update - TRENDnet TPL-410AP User Manual

TRENDnet User's Guide
Reboot and Restore
You may want to restart or restore your powerline access point if you are encountering
difficulties with your access point and have attempted all other troubleshooting.
Click on Reboot button will restart the device. Click Restore button will set the device
back to factory default settings.
Administrator User Name
Administrator Password
Access Point IP Address
Access Point Subnet Mask
Wireless Interface
Wireless Network Name/Encryption
(WPA2‐PSK AES)
Powerline Encryption Key
© Copyright 2016 TRENDnet. All Rights Reserved.
admin
admin
192.168.10.100
255.255.255.0
Enabled
Please refer to sticker or
device label
HomePlugAV
Firmware Update
TRENDnet may periodically release firmware upgrades that may add features or fix
problems associated with your TRENDnet access point model and version. To check if
there is a firmware upgrade available for your device, please check your TRENDnet model
and version using the link. http://www.trendnet.com/downloads/
In addition, it is also important to verify if the latest firmware version is newer than the
one your access point is currently running. To identify the firmware that is currently
loaded on your access point, log in to the access point, click on the Administrator section
and then on the Status. If there is a newer version available, also review the release notes
to check if there were any new features you may want or if any problems were fixed that
you may have been experiencing.
Please note the following:
 Do not interrupt the firmware upgrade process. Do not turn off the device or
press the Reset button during the upgrade.
 If you are upgrade the firmware using a laptop computer, ensure that the laptop
is connected to a power source or ensure that the battery is fully charged.
 Disable sleep mode on your computer as this may interrupt the firmware upgrade
process.
 Do not upgrade the firmware using a wireless connection, only using a wired
network connection.
 Any interruptions during the firmware upgrade process may permanently
damage your access point.
TPL‐410AP / TPL‐410APK
16