Resetting The Microprocessor - Denon AVR-3311CI Owner's Manual

ENGLISH
Symptom
Cannot login to • Login information is incorrect. Check if the Username for Napster
Napster. ("Incorrect has been properly entered. Re-enter the Password. (Password is
Username or not displayed.)
Password" is http://www.napster.com/choose/index_default.html
displayed.)
Cannot login to • Login information is incorrect. Check if the "Email address" for
Pandora. ("Email Pandora has been properly entered. Re-enter the "Password".
address" or (Password is not displayed.)
"Password" is http://www.pandora.com/denon
displayed.)
GRemote Control UnitH
Symptom
The set cannot be • Batteries are worn out. Replace with new batteries.
operated with the • Operate the remote control unit within a distance of about 23 ft /
remote control unit. 7 m from this unit and at an angle of within 30°.
• Remove any obstacle between this unit and the remote control
unit.
• Insert the batteries in the proper direction, checking the q and
w marks.
• The set's remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
116
Cause/Solution
Cause/Solution

Resetting the microprocessor

Page
86
Perform this procedure if the display is abnormal or if operations cannot be performed.
When the microprocessor is reset, all the settings are reset to their default values.
ON/STANDBY
39
Page
104
104
104
1
Turn off the power using
104
2
ON/STANDBY
Press
104
SIMULATION .
3
Once the display starts flashing at intervals of about 1 second, release the two
buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
STANDARD
DSP SIMULATION
ON/STANDBY
.
STANDARD
while simultaneously pressing
DSP
and