General; Audio/Video - D-Link MediaLounge DSM-520 User Manual

DSM-520 User's Manual Setup

General

The General option contains a submenu of four options:

Audio/Video

Aspect ratio: The aspect ratio can be adjusted to match the capture settings of your video
clips.
Video Output: You can select the video output
from this screen or by pressing the VIDEO
OUT button on the remote control from any
screen.
The Composite setting should be selected
for composite or S-Video connections. If
component connectors are used, then the
Component setting should be selected.
HDMI must be selected before playing a
video through the HDMI video connection.
If you do not select the correct connection,
the screen will have a blue tint.
Display Resolution: If HDMI or Component is selected from Video Output, then the following
five options will be made available: 480 Interlaced, 480 Progressive, 720 Progressive,
1080 Interlaced, and Auto Detection. If Composite is selected from Video Output, then the
only option made available will be 480 Interlaced.
Video Seek Mode: There are two options: FF/Rev and Jump. FF/Rev is the standard option.
With Jump you can "jump" to a time within the video. Once you make a selection here, it
will apply to all subsequent viewings until it is changed.
Audio Output: The audio output can be modified from this screen or by pressing the AUDIO
OUT button on the remote control from any screen.
If you are playing audio that has been encoded in 5.1 surround, then the sound is in
pass-through mode. This means that you cannot adjust the volume on the remote control
or Mute the sound using the remote control. With 5.1 surround audio you must control the
volume level from your digital tuner/receiver.
D-Link Systems, Inc. 95