Page 1
DELTA 8000 TAP BUS Notice d’installation Installatie-instructies Installation instructions Instrucciones para la instalación Installationsanleitung Istruzioni per l’installazione...
Page 2
CONTENTS 1/ Installation 2/ Association of the thermostat with the technical unit. with the technical unit with the technical unit...
INSTALLATION Since the temperature measurement sensor is inside the box, you 230V~ 50 Hz IMPORTANT: 230V~ 50 Hz...
Page 4
ASSOCIATION OF THE THERMOSTAT The screen displays Ln01 The screen displays CF20 >3s The screen displays CF21 The screen displays CF22. Output number Press type Heater...
THERMOSTAT CONFIGURATION measured temperature Press OK Temperature displayed in The screen displays CF01 normal mode No ban on the Thermostat's thermal the associated output Zone thermostat Thermostat type Master thermostat Master Zone thermostat thermostat Controlled Controlled Temperature management zone zone Controlled All zones zone...
Page 6
symbol Standby mode Output number Heater...
RETURN TO INITIAL SETTINGS 6.1 DELETING THE ASSOCIATION OF THE THERMOSTAT From the WITH THE TECHNICAL UNIT Press and hold the ' symbol appears. symbol disappears. Press >5s >3s...
Page 9
6.2 DELETING ALL THE ASSOCIATIONS 6.3 INITIALISING THE THERMOSTAT PARAMETERS WITH THE TECHNICAL UNIT From the The screen displays Ln01 Ln05 The screen displays rSt1 Press >3s >10s >3s >3s...
TROUBLESHOOTING TECHNICAL CHARACTERISTICS When a defect is detected on the system, the symbol flashes on the thermostat display. Press ' ' to display the type of defect. Error messages Address error. Several products were as- signed to the same output (CF20). Thermostat internal sensor shorted Thermostat internal sensor cut off Error on the outdoor sensor associated with...
Need help?
Do you have a question about the 8000 TAP BUS and is the answer not in the manual?
Questions and answers