Table of Contents
Advertisement
NORD MODULAR G2 V1.4x
devices send each other information about what changes are made on each one of them, so the
MIDI
other device keeps in sync. This way the G2 can keep track on what knobs are moved on the other device.
Note that if the G2 patch is saved, it now also saves the last knob positions on the other device, as the
Automate module had picked them up when changes were made on the other device. When the G2 patch
is recalled it will send those knob positions back to the other device, recalling its sound to what it was
when you stored the G2 patch. This way a preset of another device can be stored in a patch on the G2.
In fact, with careful use of the Patch variations eight presets of the other machine can be stored in one
G2 patch and later recalled by selecting another variation on the G2.
automation and
MIDI
the
automation section in this manual on how this module can be used in practice to control other
MIDI
instruments or
MIDI
See also
"Common MIDI module
function" on page
E
CHO
The Echo control will enable or disable the retransmission of received
conditions Echo is Off to prevent the G2 and the other instrument to endlessly send each other the same
information in an endless loop. The Echo setting simply breaks a possible endless loop. Echo On/Off
also depends on whether the other synth is in Local On or Off mode, as when the other synth is in Local
Off mode it probably breaks a possible endless loop at its own side and the G2 module must probably
be set to Echo On to still allow for two-way
very much on the capabilities of the other
own sides for
MIDI
talkback are no easy subjects. You are strongly adviced on carefully reading
MIDI
computer programs.
MIDI
parameters",
147.
MIDI
automation to work.
"Synthesis basics" on page 264
traffic. Always remember that the Echo setting depends
MIDI
device and both devices must be properly set up at their
13. Module reference: MIDI group
and
"MIDI Talkback
# values. Under normal
MIDI CC
Page 261
Advertisement
Table of Contents
