Table of Contents
Advertisement
NORD MODULAR G2 V1.4x
MIDI CHANNEL
Set the
channel for each Slot. This channel will be used for reception and transmission of
MIDI
messages.
Active check box:
MIDI
Click in the corresponding check box to activate the Slot to receive and transmit
L
O
OCAL
N
Click the Local On check box to turn the
the synth from the internal keyboard and the pedals.
In the Local Off mode, the keyboard and pedal actions are transmitted only via
the synth itself. Local Off should be used with external sequencers if the
G2 is routed back, via the external sequencer, to the
"double notes" will appear when playing the keyboard in Local On mode.
S
MIDI
ETTINGS
G
C
LOBAL
HANNEL
Here you set the Global
sending and receiving
Aftertouch and Pedals) as well as sending and receiving
mode to change to another Performance. Select Global
S
E
ID:
YS
X
Here you can set an 'Instrument SysEx ID'. This is very useful if you're sending SysEx dumps of sounds
from a sequencer to the Nord Modular G2 and have several G2 synthesizers
you have two G2 synthesizers. These two instrument models have the same 'Manufacturer ID' and
'Model ID' in the SysEx protocol. By defining separate SysEx ID's on the two synths, you will be able
to "direct" the SysEx dumps from the sequencer to one of the G2's while the other one will ignore the
dumps. Just make sure that you define a separate SysEx ID before dumping the sounds to the sequencer.
Select Instrument SysEx ID by clicking on the arrow buttons. If SysEx ID is set to All the G2 will ignore
the SysEx ID in the SysEx data and always accept the SysEx data.
S
C
:
END
LOCK
Here you choose whether or not to send out
a
Clock signal will only work when you use the internal Master Clock as clock source.
MIDI
I
E
GNORE
XTERNAL
Here you choose whether or not to accept external
the synth. If unchecked, the Master Clock of the synth will automatically sync to any incoming
Clock.
C
: R
ONTROLLERS
Here you select how the synth should handle
clicking in the respective check boxes.
P
C
ROGRAM
HANGE
Here you select how the synth should handle Program Change and Bank Select (Controller #32)
messages. Select Off, Send and Receive by clicking in the respective check boxes.
T
UNE
M
T
:
ASTER
UNE
Use this function to tune the synth to other instruments. The range is from -6 to +6 semitones and fine
adjustment from -100 to +100 cents. 100 cents is one semitone. All Oscillator modules are affected by
the Master Tune function. Select tuning with the respective arrow buttons.
G
O
LOBAL
CTAVE
MIDI
:
Channel for the synth. The Global
MIDI
note data and for sending control data (Modwheel, Aftertouch, Velocity,
MIDI
C
:
LOCK
S
:
ECEIVE AND
END
:
S
:
HIFT
Local Control on. Select Local On to be able to control
data is also transmitted via the
MIDI
jack. If Echo is active in the sequencer,
MIDI IN
MIDI
Program Change messages in Performance
MIDI
Channel by clicking the arrow buttons.
MIDI
Clock to the
MIDI
MIDI OUT
Clock signals received on the
MIDI
Controller messages. Select Off, Send and Receive by
MIDI
9. Editor menu reference: Synth menu
messages.
MIDI
MIDI OUT
and do not control
MIDI
jack of Nord Modular
MIDI OUT
Channel should be used for
connected. Let's say
MIDI
jack of the synth. Sending out
MIDI IN
MIDI
jack.
jack of
MIDI
MIDI
Page 121
Advertisement
Table of Contents
