Chamberlain GA200D Owner's Manual page 13

MEASURING AND MARKING FOR THE GATE BRACKET
2
Before proceeding, begin with the gate in the fully closed position. There are two methods described to determine
proper location of the post brackets:
• Paper template (to be cut out) located on the back page of this manual.
• Tape measure.
Either method will work depending on preference. NOTE: Be sure gate is in closed position before proceeding.
Template Method
Place the template (provided on the back page) under the gate hinge point. Use a screwdriver or dowel rod to
temporarily mark the location in front of the gate post.
LEFT SIDE BRACKET MOUNTING
Gate Post
Use a screwdriver or dowel rod to
temporarily mark measurement.
Tape Measure Method
Place the measuring tape under the gate hinge point and measure 5-1/2". Use a screwdriver or dowel rod to
temporarily mark the location of the first measurement.
LEFT SIDE BRACKET MOUNTING
Gate Post
Measure 5 1/2" from the previous mark.
Gate Post
X
5-1/2"
Use the screwdriver or dowel rod to mark the location of the second measurement.
Gate Post
Gate Hinge Point
TOP VIEW
Gate Post
Gate Hinge Point
5-1/2" X
Gate Hinge Point
Gate Post
Gate Hinge Point
First Marking
X
RIGHT SIDE BRACKET MOUNTING
Gate Hinge Point
TOP VIEW
RIGHT SIDE BRACKET MOUNTING
Gate Hinge Point
Gate Hinge Point
Gate Hinge Point
First Marking
13
Gate Post
Use a screwdriver or dowel rod to
temporarily mark measurement.
Gate Post
X 5-1/2"
Gate Post
X
5-1/2"
Gate Post
X
Gate Post
Gate Post
Installation