Adding Additional Chamberlain; Controldevices - Chamberlain GA200D Owner's Manual

Chamberlain ga200d gate openers: user guide
Table of Contents

Advertisement

Adding Additional Chamberlain Wireless
Control Devices
The gate controller has the ability to learn 9 (total) wireless
control devices such as additional remote controls or
keyless entry (see accessories):
1. To add additional Remote Control:
a. Press and release the PURPLE button on the control
board. The YELLOW LED will light continuously. The
gate controller is now ready to learn a new remote
device.
b. Press and hold the desired button on the additional
remote device until the YELLOW LED on the control
board goes out.
2. To add Keyless Entry Control (not provided):
a. Press and release the PURPLE button on the control
board. The YELLOW LED will light continuously. The
gate controller is now ready to learn password.
b. Within 30 seconds enter a four digit personal
identification number (PIN) then press the ENTER
button for approximately 3 seconds and release. The
YELLOW LED on the control board will go out.
(Temporary PIN's are not available for use with this
gate operator)
NOTE: If no radio signal is detected within 30 seconds,
the learn mode will exit automatically. To clear
programmed remotes, press and hold the PURPLE button
until the YELLOW LED goes out (about 6 seconds). This
will clear ALL learned wireless control devices.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the
battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Optional Control Connections
SINGLE BUTTON CONTROL
A wired control that functions identically to the wireless
remote control can be connected to the SWITCH +/- inputs
on the control board. Any switch with normally open
contacts and a momentary input can be used. Be sure to
unplug the Power Supply before making any electrical
connections to the control board.
S1
_
_
+
+
IR
SWITCH
R17
R6
_
_
+
+
IR
SWITCH
Advanced Programming Features
PROGRAMMING TIMER TO CLOSE (TTC)
Timer to close is a user programmable option that will
automatically close the gate after this feature has been
programmed.
a. Begin with the gate in the fully closed position, press
and hold the BLACK button for 2 seconds then
release when the YELLOW LED turns on solid.
b. Press the BLACK button X amount of times to set the
desired close delay:
1 press = 15 seconds (LED will blink 1 time)
2 press = 30 seconds (LED will blink 2 time)
3 press = 45 seconds (LED will blink 3 time)
4 press = 60 seconds (LED will blink 4 time)
5 press = 75 seconds (LED will blink 5 time)
6 press = 90 seconds (LED will blink 6 time)
7 or 0 press = TTC off (LED will turn on solid and
then go out after 10 seconds)
c. After programming the X amount of time desired,
allow 10 seconds for TTC programming to exit. You
will hear a single beep from the alarm that indicates
programming has exited.
NOTE: If the gate is open and the power is interrupted,
the TTC will be disabled. Upon another user command
the timer to close will be reactivated.
PARTY MODE
This feature allows the user to temporarily disable TTC.
With the gate in the open position, simply press and
release the RESET button located on the outside of the
control box. The gate will remain open until a user
command is given.
23
Programming

Advertisement

Table of Contents
loading

Table of Contents