Hairpin Clip - Chamberlain GA200D Owner's Manual

ATTACH BRACKETS TO GATE OPERATOR
4
Attach post bracket and gate bracket to the gate operator using the pin and the hairpin clips as illustrated.
Post Bracket
POSITION OPERATOR ON MOUNTING LOCATION
5
Before proceeding, begin with the gate in the fully closed position. The post bracket assembly can be mounted
several places on the gate post. Refer to the illustrations on page 9 for the ideal mounting options.
With gate in closed position, place operator against gate post at the desired vertical position.
• The bottom of the operator must be at least 4" off the ground.
• Temporarily secure the post bracket to the post and the gate bracket to the gate with the clamps.
• Ensure the operator is level by placing the level on the bottom of the operator.
• Ensure there is at least 1/4" space between the operator and the extension bracket. If needed the extension
bracket can be adjusted to achieve this gap. The 5-1/2" x 5-1/2" marked location may not be exact in
all installations.
5-1/2" Marked Location
Pin

Hairpin Clip

Hairpin Clip
1/4" Gap
15
Gate Bracket
Gate Operator
Gate Bracket
Clamp
Installation