Installation - Chamberlain GA200D Owner's Manual

INSTALLATION

WARNING
Mounting the Control Box and Power Supply
CAUTION
MOUNT CONTROL BOX
1
The recommended height for the control box is no
less than 4' (1.2 m) above the ground and within 1'
(.3 m) of the gate post. Do not mount control box
more than 5' (1.5 m) from gate operator. PVC conduit
(not provided) is recommended to be installed from
the control box to the power supply location.
Remove the cover screws (4) then set cover aside.
Select mounting holes within the control box that is
best suited for your application and knock out using a
screw driver or punch. Attach the control box using
the holes located within the control box and secure
with appropriate hardware (Figure 1).
AVERTISSEMENT NOTE: Be sure to clean out any debris from the control
box that may have accumulated.
Knock Outs
ATTENTION
Figure 1
S2
C42
C38
C98
D16
GATE U2 U2
FORCE
S1
R17
R6
_ _
+ +
IR SWITCH
Knock Outs
MOUNT POWER SUPPLY
2
The power supply provided must be located in a dry location that is protected from weather conditions, such as
inside the house or garage. NOTE: Do not plug power supply in until instructed to do so.
ADVERTENCIA
PRECAUCIÓN
Installation
Q7
127A0154P6
2007 36
Knock Outs
24VAC
se
Cau
g Gat e Can th at any
vin ry or Dea move
Mo Inju R! Gate ing. may gate or
CLEA ut prior warn te the
KEEP witho opera ren only nce
time not let child gate area. vehic rate les entra
Do play in the nce is for use sepa
This entra s must
Pede strian
WARNING WARNING
To reduce the risk of electric shock, this power supply
equipment has a grounding type plug, that has a grounding
pin. This plug will only fit into a grounding type outlet. If the
plug does not fit in the outlet, contact a qualified electrician to
install the proper outlet. Do not change the plug in any way.
Dry location use only.
Screw (not provided)
AVERTISSEMENT
AVERTISSEMENT
ADVERTENCIA
ADVERTENCIA
Indoor Outlet
10
WARNING
Square Gate Post
Anchors
(not provided)
Wall