Chamberlain GA200D Owner's Manual page 16

REMOVE THE OPERATOR AND MARK MOUNTING HOLES FOR DRILLING
6
Ensure gate operator is level by placing level under the gate operator. Remove gate operator
from brackets by removing the hair clips. Mark holes to be drilled. For the post bracket, mark
and drill holes in the middle of the slots to allow for minor adjustments if required. Remove
brackets and drill holes.
SECURE POST BRACKET TO GATE POST
7
HARDWARE
NOT PROVIDED
Flat Washers
Hex Nuts
Lock Washers
SECURE GATE BRACKET TO GATE
8
Mount gate bracket with appropriate hardware (not provided). If your gate is constructed of round tubular
framing, u-bolts can be used lieu of through bolt hardware.
NOTE: The gate bracket can be secured to the gate using a welder.
NOTE: Release lever must point toward the hinge post.
Installation
Carriage Bolts
Gate Bracket
1/2" holes required
for mounting
hardware provided.
NOTE: Some installations may require reinforcement of
existing gate structures for suitable support.
Reinforcement Area
16
Welder (Optional)
Welder (Optional)