AUTEC AIR Series Instruction Manual For The Use And The Maintenance
Battery and battery charger
Hide thumbs
Also See for AIR Series:
- Instruction manual (52 pages) ,
- Instruction manual for the use and the maintenance (44 pages) ,
- Original instructions manual (28 pages)
Subscribe to Our Youtube Channel
Related Manuals for AUTEC AIR Series
Summary of Contents for AUTEC AIR Series
- Page 1 LIUMB090A_eng-01 Instruction Manual for the use and the maintenance of battery and battery charger Original instructions Part E: AIRBM3V7L rechargeable battery AIRDOCK01 docking station AIR SERIES...
- Page 3 WHICH THE AUTEC CCS IS INTENDED TO BE INSTALLED, to perform an in-depth and accurate risk assessment to determine if the Autec CCS is suitable for operating a Machine in conditions of safety and operational effectiveness, taking into account the conditions...
- Page 4 It is also the responsibility of the Manufacturer and of the design professionals of the Machine on which the Autec CCS is to be installed and used to be certain that the structure, condition, organization and markings of the Machine as installed at the facility is appropriate for and will allow for the safe and reliable use and control of the Machine through the Autec CCS interface.
- Page 5 Laws, Regulations and Standards, even local, and that such Users and other Persons do in fact at all times operate or work with the Autec CCS safely and ONLY in compliance with Autec instructions and warnings and with all applicable Laws, Regulations and Standards, even local.
-
Page 7: Table Of Contents
Storage ......................16 Shipping and transportation ................17 Battery disposal ....................17 AIRDOCK01 Docking station .................. 18 Electrical connection ..................18 Positioning ....................... 20 Warnings for use ....................21 Charging ......................22 Disposal ......................22 Malfunctions ......................23 AUTEC LIUMB090A_eng-01... -
Page 8: Information On The Use Of Instructions
(Part A) of the Manual provided with the CCS. Structure of the Instruction Manual The Manual for the use and maintenance of Autec CCSs consists of different parts, that altogether form the Manual; the Manual must be read carefully, understood and applied by the CCS's Owner, User and by all those Persons that, for any reasons, may operate with the CCS or with the Machine where it is installed. - Page 9 Autec CCS and of the Machine, system, device or Machinery system where the CCS is installed. The Manufacturer of the Machine on which the Autec CCS is installed, and the Owner and User of the Machine, must make sure that the Instruction Manual and all of its parts are included in the Instruction Manual of the Machine.
-
Page 10: Caption And Terminology
Caption and terminology Contact Autec if any of the instructions, symbols, warnings or images are not clear and understandable. In this part of the Manual, the terms listed below have the same meaning explained in the corresponding paragraph of the general part (Part A):... -
Page 11: To Whom The Instructions Are Addressed
Regulation for the storage of instructions are described in the paragraph with the same title in the general part: please refer to that part. Intellectual property Restrictions connected to intellectual property are described in the paragraph with the same title in the general part: please refer to that part. AUTEC LIUMB090A_eng-01... -
Page 12: Brief Product Presentation
Station. Contacts and useful addresses The CCSs are produced by Autec Srl – Via Pomaroli, 65 - 36030 Caldogno (VI) - Italy. You can find contacts for Autec, its distributors, dealers and authorized service centres on the website www.autecsafety.com. -
Page 13: Airbm3V7L Rechargeable Battery
AIRBM3V7L rechargeable battery The object of this part of the Manual is the AIRBM3V7L battery, located inside the A8 (Model A08) Remote station of an Autec CCS, and the DC Plug Cable that is needed to recharge the Station. Always insert the battery in the Remote station, close the cover and fasten the screw: never use the Remote station if the battery cover is not fastened with its screw. -
Page 14: Warnings For Use
Warnings for use Only use original Autec batteries and only recharge batteries with battery chargers and/or power supply units provided by Autec. Never use damaged batteries (e.g. crushed, punctured, swollen or leaking batteries). Never use batteries if they have been dropped even just once, as their internal components may have been damaged, even though this cannot be seen from the outside. -
Page 15: First Aid
Do not attempt to repair damaged or faulty batteries. Autec cannot be held responsible for any use that does not comply with the provisions and directions provided in the Manual, and for any damage that may result from improper, incorrect or irrational use of the battery. -
Page 16: Storage
Do not expose the battery to direct sunlight for a long time. Do not store fully charged or flat batteries for a long time. After long idle periods, it may be needed to carry out several battery discharge/ charge cycles to achieve the best performance. LIUMB090A_eng-01 AUTEC... -
Page 17: Shipping And Transportation
The crossed-out wheeled bin marked on batteries indicates that they must be disposed of separately from household waste, in conformity with the EU Directive 2006/66/EC and its amendments, and with local regulations. AUTEC LIUMB090A_eng-01... -
Page 18: Airdock01 Docking Station
AIRDOCK01 Docking station The AIRDOCK01 Docking station can only be used to recharge the Air series' A8 (Model A08) Remote station. Socket Remote station's seat Contacts A A8 (Model A08) Remote station must only be recharged through the AIRDOCK01 Docking station supplied by Autec. - Page 19 The Docking station AIRDOCK01 can be powered exclusively by the wall-mount power supply unit or by the car power supply unit originally provided by Autec. Never use the Docking Station and the power supply unit if they are damaged. The power supply unit must be connected to a socket that can be easily reached and disconnected.
-
Page 20: Positioning
The Docking station AIRDOCK01 must be placed in the "SAFE AREA", i.e. without explosion-risk gases and/or dusts. Do not put any objects over the Docking Station, especially over its contacts. Do not in any case perforate, modify or tamper with the Docking Station. LIUMB090A_eng-01 AUTEC... -
Page 21: Warnings For Use
Docking Station, because they can compromise its use and safety. Autec cannot be held responsible for any use that does not comply with the provisions and directions provided in the Manual, and for any damage that may result from improper, incorrect or irrational use of the Docking Station and of the power supply unit. -
Page 22: Charging
When disposing of Docking stations and of power supply units, their components must be managed as separate waste. When disposing of Docking stations and of power supply units, please comply with the provisions and/or the regulations in force in the country where they are used. LIUMB090A_eng-01 AUTEC... -
Page 23: Malfunctions
Faulty Remote station. Replace the Remote station. Faulty battery. Replace the battery. To make sure that the red LED is lit with feeble light, press the START pushbutton when the STOP pushbutton is activated: the red LED's brightness intensifies significantly. AUTEC LIUMB090A_eng-01... - Page 24 Via Pomaroli, 65 - 36030 Caldogno (VI) - Italy Tel. +39 0444 901000 - Fax +39 0444 901011 info@autecsafety.com - www.autecsafety.com MADE IN ITALY...
Need help?
Do you have a question about the AIR Series and is the answer not in the manual?
Questions and answers