AUTEC Air Series Manual
Menu of transmitting unit
Hide thumbs
Also See for Air Series:
- Instruction manual (52 pages) ,
- Instruction manual for the use and the maintenance (44 pages) ,
- Original instructions manual (28 pages)
Related Manuals for AUTEC Air Series
Summary of Contents for AUTEC Air Series
- Page 1 Menu of Transmitting Unit (MTU) AIR SERIES STOP FUNCT. START Menu of Transmitting Unit (MTU)
- Page 3 Contact Autec if any of the instructions and/or warnings provided in this manual are not clear. No part of this manual may be reproduced, in any form or by any means, without written permission of Autec (including re- cording and photocopying).
- Page 4 Settings saved in the transmitting unit are lost when the UNPAIR procedure is performed. All AIR series radio remote controls with Serial Number lower than GA01560 and all back-up transmitting units with “MANUF. DATE 2011” do not require to enter the PIN code when performing the procedures described in the PIN START UP, PIN CODE, SWITCH OFF and UNPAIR submenus.
- Page 5 The PIN code used to start up the radio remote control complies with this requirement. Autec cannot be held responsible if this PIN is disabled. Carry out the following procedure with the transmitting unit switched off and the STOP pushbutton released.
- Page 6 If you try and start the radio remote control after the UNPAIR procedure, the green and red LEDs illuminate to signal that the transmitting unit is not paired with any receiving unit. AUTEC - Air Series LIIMTU00E1-00.fm A8 - Configuration Menu...
- Page 8 Autec srl - via pomaroli, 65 - 36030 Caldogno - Italy - phone +39.0444.901000 - fax +39.0444.901011 - info@autecsafety.com - www.autecsafety.com...
Need help?
Do you have a question about the Air Series and is the answer not in the manual?
Questions and answers