AUTEC Air Series Manual

Hide thumbs Also See for Air Series:

Download this manual

Information provided in this manual is used for the installation of the radio remote con-

trol on the machine and for its maintenance.

Information provided in this manual allows to disable, enable and set some radio remote

control's functions that may have impacts on the risk assessment related to the ma-

chine; this assessment must be carried out to decide whether the machine can be radio

remote controlled.

Information provided in this manual cannot be used and performed by people who are

not competent, responsible for and authorized to do that.

The person in charge for the machinery's safety must keep information contained in this

manual reserved.

Those who use this information must also have been trained about the radio remote

control and its risks by Autec's personnell or by people authorized by Autec.

Autec srl cannot be held liable for responsibilities resulting from the modification of

these functionalities.

AIR SERIES

Transmitting unit with "ID memory key"

Menu of Transmitting Unit (MTU)

IMPORTANT INFORMATION

Menu of Transmitting Unit (MTU)

Page 1 Those who use this information must also have been trained about the radio remote control and its risks by Autec's personnell or by people authorized by Autec. Autec srl cannot be held liable for responsibilities resulting from the modification of these functionalities.
Page 3: General Section
Contact Autec if any of the instructions and/or warnings provided in this manual are not clear. No part of this manual may be reproduced, in any form or by any means, without written permission of Autec (including re- cording and photocopying).
Page 4: Switch Off
Hence, only the person responsible for such tasks can de- cide to modify settings through the MTU. Autec cannot be held liable for responsibilities resulting from the modification of these functionalities. The MTU has four submenus: 1.
Page 5 “Key ID 0-1” and/or the PIN code used to start up the system make the radio remote control compliant with such requirement. Autec cannot be held responsible if this PIN is disabled. The PIN START UP submenu is used to disable/enable the radio remote control start up with PIN code.
Page 6 To restore the radio link at the end of this procedure, perform the ALIGNMENT procedure If you try to start the radio remote control after the UNPAIR procedure, the green and the red LEDs light up. AUTEC - Air Series LIIMTUAKE0-00.fm...
Page 8 Autec srl - via pomaroli, 65 - 36030 Caldogno - Italy - phone +39.0444.901000 - fax +39.0444.901011 - info@autecsafety.com - www.autecsafety.com...