Table of Contents
Advertisement
Original instructions
1
Description ............................................................................................................ 2
2
Technical data ....................................................................................................... 3
3
Technical data sheet ............................................................................................. 4
4
Plates ..................................................................................................................... 4
4.1 Plates on MVRL9E unit in a radio remote control ............................................. 4
4.2 Plates on MVRL9E unit in a Take & Release radio remote control ................... 4
5
Light signals .......................................................................................................... 5
5.1 POWER LED (green) ....................................................................................... 5
5.2 ENABLE LED (green) ...................................................................................... 5
6
Operation ............................................................................................................... 6
6.1 Electronic module ............................................................................................ 6
6.2 DIP switches .................................................................................................... 6
6.3 Internal light signals ......................................................................................... 6
6.4 Command outputs ............................................................................................ 6
7
Malfunction signalled by the receiving unit ........................................................ 7
AUTEC
Air series
Part D: receiving unit
MVrL9e (rrL)
inDex
LIRRLE00-01
Advertisement
Table of Contents
Related Manuals for AUTEC MVRL9E
Summary of Contents for AUTEC MVRL9E
- Page 1 4.1 Plates on MVRL9E unit in a radio remote control ..........4 4.2 Plates on MVRL9E unit in a Take & Release radio remote control ....4 4.3 Plates on MVRL9E unit in a Multi Units or Multi Receiver radio remote control 5 Light signals ......................5 5.1 POWER LED (green) ..................
- Page 2 Connector for AC power supply SAFETY contacts protection fuses Connector for the cable control's wiring SAFETY outputs STOP outputs Connectors for DC power supply DC power supply protection fuse Optional card (with related command outputs) LIRRLE00-01 AUTEC - Air series...
- Page 3 RADIO MODULE AirrT32nM FREQUENCY 433.050-434.790MHz FREQUENCY 433.050-434.790MHz N12335 N12335 FREQUENCY 915-928MHz FREQUENCY 915-928MHz TA1287-00 A0TARG01P1026 TA1287-00 A0TARG01P1026 S/N: XXXXXX S/N: XXXXXX MANIF. DATE XXXX MANIF. DATE XXXX POWER ENABLE POWER ENABLE 290mm (11.42in) 340mm (13.39in) AUTEC - Air series LIRRLE00-01...
- Page 4 On the cover of the technical data plate technical data, marking and possible receiving unit. radio remote control marks. Plates on MVrL9e unit in a Take & release radio remote control Plate Position Content radio remote control On the cover of the...
- Page 5 Light signals Plates on MVrL9e unit in a Multi Units or Multi receiver radio remote control Plate Position Content Radio remote control serial number radio remote control On the cover of each (MULTI S/N), bar code and identification plate receiving unit.
- Page 6 The activation of each relay on the mother board is signalled by an LED near the relay. Command outputs The data sheet contains information regarding the correspondence between the commands sent by the transmitting unit and the related output enabled in the receiving unit. LIRRLE00-01 AUTEC - Air series...
- Page 7 Check the protection fuses of the STOP LeD blinks fast. the commands sent. contacts or of the SAFETY contacts and, if needed, replace them. AUTEC - Air series LIRRLE00-01...
Need help?
Do you have a question about the MVRL9E and is the answer not in the manual?
Questions and answers