Intended Use; Raw Material Requirements; Getting Started - RoboLabs ROBOJETFLOSS ACB-09-120 Operating Manual

tm2620/tm2627 Apr-20
The front panel has the following controls: Switch (11) turns on the electric motor
which rotates the spinning head; Switch (12) turns on the heating element;
Adjustment Knob (13) regulates power to the heating element and thus controls its
temperature; Voltmeter (14) indicates actual voltage supplied to the heating
element.
The 'PRO' version includes a 'Quick Start' button (15) which temporarily sends
maximum power to the heating element, even when the electric motor is not
running.
See the figure above for machine front panel. Appearance may vary depending on
the modification (230 Vac 50 Hz or 120 Vac 60 Hz).

2. Intended use

2.1. Raw material requirements

Use only 100% pure sugar (beet or cane) with flossine or ready to use flossugar.
Do not use sugars with starch, dextrose or similar additives as they can result in
poor quality floss and/or clog the heater coil assembly.

2.2. Getting started

Unpack machine and save materials for future shipping needs.
Place the machine on a stable table or cart.
Before attaching power cord, fully raise all four transportation fastening nuts (16)
until they reach the rubber floss pan supports.
Transportation position Operation position
TURNING ON THE MACHINE WITHOUT RAISING FASTENING NUTS WILL RESULT IN MACHINE
FAILURE!
Wash silicone ring and silicone collar with dish soap. Carefully install silicone ring
on the stator. Adjust the exposed gap on the stator intake to regulate airflow
depending on ambient conditions.
8