Dealer-Programmable Functions; A E Led - Icom IC-F3/S Instruction Manual

|
3 DEALER-PROGRAMMABLE FUNCTIONS
E Functions
In the following explanations, programmable function names
are bracketed, the specific switch used to activate the func-
tion depends on programming.
© KEYPAD LOCK FUNCTION
This function locks access to all programmable switches (ex-
cept the switch assigned the lock function).
To toggle the lock function ON and OFF:
Push and hold the [LOCK] switch for 1 sec.
°" w0 "appears while the lock function is ON.
* This function may be inhibited on some channels.
© PRIORITY CHANNEL
This function is used to select a pre-programmed channel at
the push of a switch.
To select the priority channel:
Push the [PRIORITY] switch.
¢"PRIO" appears briefly, then the priority channel is automatically se-
lected.
© SCAN FUNCTION
The scan function allows you to search a pre-programmed
group of channels for signals.
To start/stop scan:
Push the [SCAN] switch.
e Scan pauses on a channel when receiving a signal.
Depending on programming, a message may appear while scan-
ning.
*"Lockout SCAN" (pre-programmed list SCAN) or "Priority SCAN"
can be pre-programmed.
¢When the "Power-save function' is activated, the transceiver checks
all pre-programmed channels then returns to the "Power-save func-
tion" again.
© BEEP FUNCTION
This function provides confirmation beep tones when push-
ing switches.
To toggle the function ON and OFF:
Push the [BEEP] switch.