Smarttrunk Iim Operation - Icom IC-F3/S Instruction Manual

SmarTrunk II™ OPERATION
E Basic operation
These features are enabled by your Dealer or System
Operator and may not be available in your system. Contact
your Dealer for details.
Push the [Bank Up] switch one or more times to select a
channel bank for conventional channels or SmarTrunk ||TM
channels.
¢Scanning starts when a channel bank for SmarTrunk II™ is
selected.
© PTT dispatch operation *'
@ Push [PTT] once (without dialing) to initiate a dispatch call.
@ Begin talking after you hear three beeps (one short, high-
pitched, two very-short, low-pitched).
@ Receiving a dispatch call is indicated by the same three-
beep sequence.
elt is not necessary to push [*] to answer a dispatch call.
© System busy indication
If all channels are busy, three low beeps sound after you initi-
ate a call. Try the call again later.
© Receiving a subscriber-to-subscriber call *!
When you hear ringing, push [*] to answer.
¢For a group call, you hear a short ring followed by two short
beeps. You do not have to answer a group call to hear it over
the air.
© Receiving a landline-to-subscriber call *!
When you hear ringing, push [*] to answer.
¢For a group call, you hear a short ring followed by two short
beeps. You do not have to answer a group call to hear it over
the air.
© Terminating a call "1!
After completing a call, push [#] to disconnect (hang up).
IMPORTANT: If one person in the conversation terminates a
call, all participants will be cut off.
© Last number redial *'
Push [*], [2] to automatically redial the last number called.
"A high-pitched beep indicates that the number is accepted.
"1: This function is available for the IC-F3S/IC-F4S when the
[AVIW] keys are assigned the [ * ]/[#] key functions.
=
a