Icom IC-F3/S Instruction Manual page 12

5 SmarTrunk IIM OPERATION
© Clear channel alerting *'
If all channels are busy, the transceiver automatically begins
searching for an open channel and beeps every ten seconds.
When two short beeps (low-pitched, then high-pitched) are
heard, a channel is available. Push [*], [*] immediately to
redial the last number.
© Turbo SpeeDial
To automatically dial a commonly used number with one
push:
Push one of the turbo SpeeDials :
IC-F3/IC-F4: [A], [B], [C] or [D]
IC-F3S/IC-F4S: [P0],[P1], [P2], [P3], or [A]
© Programming memory speed dial
@ Push and hold [*] until you hear a high-pitched beep.
@ Enter the memory location (0-9, A, B, C, D), the telephone
or subscriber number, then [1], [*] (or [3], [+] if for another
system subscriber).
"A high-pitched beep indicates successful programming.
e Memories [AJAD] are used for the Turbo SpeeDial.
NOTE: This function is available for the IC-F3/IC-F4 only.
© Emergency call "2
Push [0], [*] to initiate an emergency call.
¢Contact your Dealer for details.
© Memory speed-dialing "2
To automatically dial a commonly used number from memory:
#Push [*] followed by the memory location (0-9).
© Placing a telephone call *2
Enter the phone number followed by [1], [*].
"A high-pitched beep indicates that the number is accepted.
When the called party answers, push the [PTT] switch to
talk, and release it to listen.
© Calling another local system subscriber "2
Enter the subscriber number followed by [3], [*].
"A high-pitched beep indicates that the number is accepted.
e You hear ringing, then two short beeps when the subscriber
answers.
e |f the other subscriber is on another call or out of range, you
hear a fast busy signal and the call terminates automatically.
"1: This function is available for the IC-F3S/IC-F4S when the
[AVIW] keys are assigned the [ * }/[#] key functions.
*2: This function is available for the IC-F3/IC-F4 only.
Use the Turbo SpeeDial function instead.
For additional operating instructions, contact your Dealer
or System Operator.