Casablanca Brescia Owner's Manual page 9

INSTALLING THE SWITCH HOUSING ASSEMBLY
Step 13. Attach the two (2) 5-32 X
switch housing screws removed in Step 8
to fan motor as shown, leaving 1/8" space
for the switch housing installation.
Step 14. Lift the switch housing, run-
ning the switch housing screws through
the keyholes. Turn the switch housing
right (clockwise) to engage the keyholes.
Tighten securely by hand only.
Step 15. Line up the two clearance holes
in the cap with the two threaded holes
on the raised rim of the switch housing.
Press the cap onto the switch housing to
seat the guide pins into the alignment
holes of the switch housing.
Step 16. Using the two (2) 8-32 X
screws removed in Step 12, install the
cap onto the switch housing.
Tighten securely by hand only.
Step 17. You may now proceed to the fan
control system for your fan.
For 3-Speed models (with pull chain), please
see the directions on Page 9.
For Inteli•Touch (wall control) operation,
please see the instructions on Page 10.
8
9
/
32
KEYHOLE
SWITCH HOUSING
MOUNT SCREW
9
5-32 X /
32
(2)
INSTALLING THE CAP
3
/
8
CAP SCREW
8-32 X 3 /
8
(2)
FAN CONTROLS
PAGE 9
R
PAGE 10