Replacing The Lamp; About The Replacing Lamp - Canon ReallS SX80 User Manual

Replacing the Lamp

When the time of use of the lamp exceeds the certain amount of time, the following mes-
sage (two types) is displayed for 10 seconds every time the projector is turned on.
1,800 - less than 2,000 hours
• This message will not be displayed again if you select [Cancel] in response to the mes-
sage "Do you want to display this message again?".
Over 2,000 hours
• After the above screens (two types) have been displayed for 10 seconds and disap-
peared, all buttons become operable.
• You can check the time of use of the lamp in [Lamp counter] in the [System settings]
menu (P98).

■About the Replacing Lamp

This projector uses the following lamp.
Lamp type No.RS-LP05
• Be sure to use the specified lamp.
• A lamp can be ordered from your dealer.
• When replacing the lamp, turn off the projector, wait until the cooling fan stops, remove the
Caution
power plug from the AC outlet, and let the projector stand for at least 1 hour. Otherwise, you
may get burned because the main unit is very hot immediately after the projector is turned off.
• Do not touch the inner glass surface when you replace the lamp. Otherwise, the projector 's
performance may degrade.
• Make sure to handle the lamp carefully and correctly since it may explode if it is scratched or
shocked. If a lamp explodes, follow the instructions under "If a Lamp Explodes" on page 16.
• Do not remove screws unless specified.
* [<] / [>], the OK button, and the POWER but-
ton are available during this message is dis-
played.
(When you press the POWER button, "Push
POWER button again to turn off the power."
message appears.)
* The POWER button is available during this
message is displayed.
(When you press the POWER button, "Push
POWER button again to turn off the power."
message appears.)
129
Maintenance