Table of Contents
Advertisement
Troubleshooting
WARNING Lamp Flash Patterns
The WARNING lamp on the Control Panel flashes in red when there is a trouble in the pro-
jector.
• Turn off the projector, wait until the cooling fan stops, and remove the power plug from
the AC outlet before dealing with the trouble.
Flash Pattern
Meaning
One flash
Temperature,
abnormality
Two flashes
Faulty lamp
Three flashes
Faulty lamp
cover
Four flashes
Faulty cooling
fan
Five flashes
Faulty power
supply
Six flashes
System failure
The temperature inside the projector is too high for some reason
or the outside air temperature is higher than the specified one. If
the problem is inside the projector, check whether the projector
is installed and operated normally, turn off the projector to cool
its inside, and retry projection. If the air intake or exhaust vent is
blocked, remove the obstacle. If the same warning occurs
again, the projector may be defective. Contact your dealer.
The lamp has burnt out. Replace the lamp with a new one. If the
same warning is experienced again, the lamp drive circuit may
be defective. Contact your dealer.
The lamp cover is open. Turn off the projector and unplug it from
the power outlet, then install the lamp cover and turn on the pro-
jector again.
If the lamp cover has been installed properly, the lamp cover
detection switch may be defective. Contact your dealer.
The cooling fan or another component may be defective. Con-
tact your dealer.
The abnormal voltage is applied to some parts in the power
supply or any other failure may be occurred. Turn off the projec-
tor and unplug it from the power outlet, then plug it to the outlet
and turn on the projector again. Contact your dealer if the same
warning is given.
Some of the functions may be defective. Turn off the projector
and retry projection. If the same warning is experienced again,
contact your dealer.
122
Countermeasure
Advertisement
Table of Contents
