If You Want To Reset The Network Setting; Error Notification Message - Canon ReallS SX80 User Manual

Canon realls sx80: user guide
Table of Contents

Advertisement

6
Click [Apply] in the menu. When "Save and apply settings. OK?" message appears,
click the [OK] button.
This completes the IP address setting of the projector.

■If You Want to Reset the Network Setting

1
Access to the projector from web browser by performing the step 1 on "Setting Net-
work (P117)."
2
Click [Initialize] in the network setting page.
3
Click the [OK] button when "Initialize network settings?" message appears.
• To restore the settings with the projector operation, execute [Network setting initial-
ization] from the menu.

■Error Notification Message

If errors occur in the projector, the following messages are sent.
Error list
Error name
Errors related to
temperature
Text
Error name
Errors related to
the lamp
Text
Error name
Errors related to
the lamp cover
Text
Error name
Errors related to
the cooling fan
Text
Error name
Errors related to
the power supply
Text
Error name
Other types of
errors
Text
* Contact your Canon dealer.
Temperature abnormality
The temperature inside the projector is too high for some
reason or the outside air temperature is higher than the
specified one. If the problem is inside the projector,
check whether the projector is installed and operated
normally, turn off the projector to cool its inside, and retry
projection. If the same warning occurs again, the projec-
tor may be defective. Contact your dealer.
Faulty lamp
The lamp has burnt out. Replace the lamp with a new
one. If the same warning occurs again, the lamp drive
circuit may be defective. Contact your dealer.
Faulty lamp cover
The lamp cover is open. Check whether the lamp cover
is installed properly. If it is installed properly, the lamp
cover detection switch may be defective. Contact your
dealer.
Faulty cooling fan
The cooling fan or another component may be defective.
Contact your dealer.
Faulty power supply
The voltage of part of the power supply is abnormally
high or any other problem has occurred in the power
supply. Contact your dealer.
Unknown Error
Codes in hexadecimal numbers*
119
Setting an IP Address

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sx80 - realis sxga+ lcos projector2677b002Sx80

Table of Contents