Futech MULTICROSS 3D User Manual page 6

· Make sure the Pendulum lock [03] is in the
"Lock" position.
· Switch on the laser by holding the Power button
[A] for approx. 3 seconds.
The laser lines switch on with the pendulum
locked.
Now, the laser line can be set to the desired
slope by tilting the device accordingly.
NOTE
The laser lines are not levelled using the
manual slope mode therefor the warning
triangle [H] starts fl ashing! To remind you, the
laser line will blink shortly every 10 seconds.
· To turn off the laser in manual slope mode,
hold the Power button [A] again for 3 seconds
or shift he Pendulum lock [03] to the "unlock"
position and back to the "lock" position.
CHOOSE HORIZONTAL AND VERTICAL LINES
At times, you may not require all laser lines,
make it useful to activate only the ones needed.
Therefore, you have the option to deactivate or
activate specifi c laser lines as desired.
6
If all laser lines are switched off, the warning
triangle [H] will fl ash at a fast rate and the laser
!
will beep every 10 seconds.
When working in manual slope mode and a laser
line is activated the warning triangle [H] will fl ash.
HORIZONTAL LINES
· Press the Upper horizontal lines button [F] to
activate the upper horizontal line.
· Press the bottom horizontal laser line button
[G] to activate the bottom laser line. (Only for
MC4D)
NOTE
We advise to set the horizontal line on your
working height.
...
  

...

...
