Futech MULTICROSS 3D User Manual page 5

USE
SELF LEVELLING MODE
· Shift the Pendulum lock [03] to the "Unlock"
position to unlock the pendulum and switch on
the laser.
At this point the laser is able to level itself.
The device is capable of self-levelling within a
range of approximately 3,5°. Ensure the
instrument is not placed on a slope exceeding
this limit.
Should the slope exceed 3,5°, the laser lines will
blink fast and the laser will start beeping.
· To switch off the laser, shift the Pendulum lock
[03] to the "Lock" position.
Now the laser is switched off and the penulum is
locked again.
MANUAL SLOPE MODE
In manual slope mode, you can set slopes with
the Multicross 3D/4D 18V MAX.
This means the laser lines will be projected
with the pendulum locked. This gives you the
opportunity to project sloped lines under the
angle you need.
5