Evenflo Revolve360 Extend Owner's Manual page 94

IMPORTANT: You may use the Tether Strap and Lower Anchor Connectors to
secure this booster seat to the vehicle seat as long as the position of the booster
seat in the vehicle and/or the resulting fit of the vehicle seat belt over the child are
not affected.
3. Remove LATCH/UAS anchors from
storage locations on back side of
base. Remove each connector by
pulling out on red release strap.
4. Remove Tether from Tether Storage
Location under the Base and place
the Base in an approved rear vehicle
seating location. Make sure the
Base lies flat on the vehicle seat and
firmly up against the seat back.
94
Booster Mode (Forward-Facing Only)
Installing the Booster