Datascope System 98 Service Manual page 71

1.3.14 DOPPLER INFORMATION
The doppler used with the System 98 is the Huntleigh Mini Dopplex®. This
doppler uses ultrasound techniques to detect vascular blood flow
To use the doppler:
1. Open the top storage bin. The
+ doppler is located inside the door
panel.
Remove the doppler from the
storage bin. Press the button on
the tether reel to retract the
doppler.
3. If battery replacement is necessary,
remove the cover of the battery
compartment, and lift our the
old battery. Install a new OLRSGI,
6LF22, or equivalent 9V alkaline
battery. Replace cover.
gel on the transducer or the
patient's skin.
5. Turn on the unit and position
the probe over the artery to be
considered.
6. Hold the probe at a 45° angle to
the surface of the skin. Adjust the
position and angle of the probe to
obtain che optimum audio signal.
Refer co the Huntleigh Operators
Manual for more detailed instructions.
Place a liberal amount of coupling
Wavetorm — E Headphone
Socket ーー | Socket
LCD Display = vi
OA 1
| LOT Probe Holder |
| Loudspeaker Ses]
93881 | |
Coo | Probe |
vio | |
Sİ
At i
i
On/Off muton | A |
ГА |
ти 는 |
nl
Probe Cable i, T Probe |
| Connector !
i |
Pocket Clip エ ーー E
E, (contro!
Attachment
κ
1
圖
i
o
ml
(JS
Volume
—— Ca! Button
Battery i
Compartment |
|
*The System 98 transmits both Assisted and Unassisted Systolic and Diastolic Pressures.
Figure 1-48
Doppler, Front View
Figure 1-49
Doppler, Rear View
System 98 Service Manual
Chapter 1, Operation
1-67