Positioning; Fb775 Positioning Requirements & Working Space - Intec ColorCut FB77 Series Installation & Setup Manual

Dual tool, flatbed digital die-cutters
Table of Contents

Advertisement

1.6 POSITIONING

The Intec ColorCut FB775 weighs 96Kg, while the larger FB1175 weighs 108kg. Both
are supplied with a stand to provide an ergonomic working height. When deciding
on where to position the cutter, follow the description applicable to your cutter for
dimensions and working area on the following pages.
Be careful to leave space behind the cutter to allow for movement of the main
beam forwards and backwards for the length of the table, and that no cables or
items behind the cutter, obstruct the beams' movements.
1.6.1 FB775 Positioning Requirements & Working Space
1. Working Space is different to Machine dimensions.
2. Ensure there is sufficient space at the rear of the FB775 to enable the Beam car-
riage to move freely and without obstructions.
3. Ensure there is sufficient space above the FB775 to enable the carriage beam to
move easily and ensure that are no obstructions, that may prevent you from easily
pressing the Emergency Stop Switch in case of a problem.
4. Ensure there is space in front of the machine to operate the control panel and to
position sheets easily upon the machine.
5. Ensure there is space to the side of the machine for the Vacuum pump and the
vacuum pump hose.
Working Space
Intec Printing Solutions - Manual for ColorCut flat bed series FB775/FB1175 ........................................................................................................... Page No: 16
Working Space
1,550mm
(61") wide
1280mm (50.3") Physical width

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ColorCut FB77 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Colorcut fb1175 seriesColorcut fb775

Table of Contents