Intec ColorCut FB77 Series Installation & Setup Manual page 9

INTEC COLORCUT SC5000 - SPECIFICATIONS
MEDIA HANDLING
Standard media sizes
Maximum Media Size
Maximum Effective
Cutting Area
Media thickness
(Cutting Depth)
Media Hold
DUAL TOOL CARRIAGE
Tool Carriage Speed
Mountable tools (Tool1)
Tool1 (force)
Mountable tools (Tool2)
Tool2 (force)
Blade Holder
REGISTRATION CONTROL & JOB MANAGEMENT
Registration system
Cut position accuracy
Auto job recognition
Intec Printing Solutions - Manual for ColorCut flat bed series FB775/FB1175 ................................................................................................................. Page No: 9
FB775
A4 (210 x 297mm), A3 (297 × 420mm),
SRA3 (320 × 450mm), SRA2 (450 ×
640mm), also 2 x SRA3 at same time.
570 x 800mm
475 x 725mm
0.17mm (150g/m²) - 0.1000mm (850g/m²)*
(Typically normal paper-card up to 750µ (0.75mm), soft card (Air freshener board up to 1000µ)
Vacuum Table, (750W Vacuum pump inc.)
Both tools provide variable speed - Three speed modes: Fast mode up to 1,200mm/s;
SD Standard mode up to 960mm/s; HD High quality mode up to 750mm/s
14 Ø Blade Holder
(Supplied)
mm
Contour cutter, with up to 1,200gf (11.77N) delivered in 190 steps programmable
through Intec ColorCut Pro cutting software
14 Ø Creasing Tool
(Supplied)
mm
Contour cutter, with up to 1,500gf (14.71N) delivered in 190 steps programmable
through Intec ColorCut Pro cutting software
Supports 0.9mm Ø, 30 , 45
O O
Supports 1.5mm Ø , 45 Industrial Cir-clip Blades for Die-Cutting up to 1000μ card.
O
Vision3 - 8th generation High resolution CCD vision system reads registration marks on
media, automatically adjusting cut lines to correct for scale or skew.
+/- 125 micron*
(* Note: accuracy based on Registration targets applied)
Yes: Cut file retrieval, supported through QR code (requires ColorCut Pro)
A4 (210 x 297mm), A3 (297 × 420mm),
SRA3 (320 × 450mm), SRA2 (450 ×
640mm), SRA1 (640 × 900mm), 4 x SRA3
at same time), or B1+ (720x1020mm)
830 x 1180mm
730x1080mm
Vacuum Table, (1000W Vacuum pump inc.)
& calibration pen
(Supplied)
,
14mm Ø Blade Holder (optional) for dual blade mode
or 60 Cutting Blades for labels & thin media &
O
FB1175
for auto-calibration