Table of Contents
Advertisement
2 - SETTING UP A WI-FI HOTSPOT
The FB775/1175 series of cutters use a Vision3 registration system in conjunction with
the ColorCut Pro software to identify your cutting registration marks (PageMarks), and
to read the QR code for retrieving job numbers.
Please Note: ColorCut Pro does NOT require a live video feed to do this,
your cutting will work perfectly fine with no video connection as all this is
all handled in the cutter. However, in addition to the 'on-board' registration
and QR code handling, the Vision3 registration camera's control system
includes an image echo function that broadcasts the video feed from the
Vision3 sensor over Wi-Fi. You can connect to the live video stream using
the ColorCut Pro application and view the video feed which is useful when
cutting, helping you to identify issues and so you can see while placing
sheets if you are working in a manual mode. manually, We do recommend
you do enable this feature. Please follow the guide below on how to connect
to the live video feed before launching ColorCut Pro.
2.1 Using Wi-Fi to connect the FB775/1175 - Live Video Feed
The FB775/1175's Vision3 registration system has a camera image echo function
which sends the live video feed that the registration sensor is seeing, as an echo that
is transmitted through WLAN. To connect to the Video feed, you will establish a Direct
Wi-Fi connection from the computer that is running ColorCut Pro.
The FB775/1157 cutter will only connect to a 2.4GHz Wi-Fi Direct connection or Wifi-
HotSpot defined as follows:
SSID:
Password:
If your computer is not a laptop, then you may not have Wi-Fi capabilities on your PC,
therefore your Intec FB775/1175 is supplied with a USB Wi-Fi Dongle
to do this.
If you are connected on a PC with a Wi-Fi connection (such as a laptop you can ignore
this step).
Intec Printing Solutions - Manual for ColorCut flat bed series FB775/FB1175 ........................................................................................................... Page No: 18
H3
12345678
1. Insert the Wi-Fi Dongle supplied with the
FB775/1175 cutter.
B
2. When the dongle is recognised, please install
the drivers (supplied in the Wi-Fi dongle box).
B
. to enable you
Advertisement
Table of Contents
Need help?
Do you have a question about the ColorCut FB77 Series and is the answer not in the manual?