Cutter Blades (An Overview Of Blade Types) - Intec ColorCut FB77 Series Installation & Setup Manual

4.1 CUTTER BLADES (An overview of Blade types)

Your cutter comes with a selection of blades. The blades are packed in a foam
packing material. In addition to this there is a colored rubber protective cap. The
yellow caps indicate 30
blades. Be careful when handling the blade as the cutting end is very sharp. Blades
are selected for different applications; a guide is shown below:
Name
Blade
Circlip
Knife
Creasing
Blade
Pen
Holder
* Maximum cutting depth is defined by the machine type rather than the blade (which is 600 microns)
Intec Printing Solutions - Manual for ColorCut flat bed series FB775/FB1175 ............................................................................................................... Page No: 44
, red caps indicate a 45
O
Image Angle
Diameter
30
O
45
O
60
O
45
O
60
O
blade while the blue caps are 60
O
Blade
Features and Application
For Film, very soft material, thin
1mm
label material.
Typically for labels, stickers,
1mm
and very thin paper/card,
For hard media. The sharply
angled tip provides a sharper
1mm
point edge. Suitable for penetrating
harder media types.
Most packing board up to 500
micron. Circlip provides better
pressure and improves blade
1.4mm
direction changes on dense media.
Suitable for cutting media from 0.25
to 0.5 mm thick
For cutting high-intensity reflective
film, magnetic media or thick media.
The sharply angled tip provides a
1.4mm
longer cutting edge. Suitable for
cutting media from 0.5 to 1.5 mm
thick.* For cutting sandblast rubber.
Bearing-based creasing ball,
double-ended for different width
creasing. Suitable for media ≤500g
Cardboard, corrugated paper
Used at setup, to calibrate the offset
between the Optical Registration
Mark sensor (Red light) and the
centre of Tool1 (The blade).
O