Table of Contents
Advertisement
1.6.2 FB1175 Positioning Requirements & Working Space
1. Working Space is different to Machine dimensions.
2. Ensure there is sufficient space at the rear of the FB1175 to enable the Beam car-
riage to move freely and without obstructions.
3. Ensure there is sufficient space above the FB1175 to enable the carriage beam to
move easily and ensure that are no obstructions, that may prevent you from easily
pressing the Emergency Stop Switch in case of a problem.
4. Ensure there is space in front of the machine to operate the control panel and to
position sheets easily upon the machine.
5. Ensure there is space to the side of the machine for the
Vacuum pump and the vacuum pump hose.
Working Space
1550mm (61") Physical width
Intec Printing Solutions - Manual for ColorCut flat bed series FB775/FB1175 ............................................................................................................... Page No: 17
Working Space
2,150mm
(84.6") wide
Advertisement
Table of Contents
Need help?
Do you have a question about the ColorCut FB77 Series and is the answer not in the manual?