Installing The Security Cover; Mount The Ap-8 To A Ceiling - Avaya AP-8 User Manual

Hardware Installation

4. Installing the Security Cover

You can optionally install a security cover to deter unauthorized
access to the AP-8. The security cover is a plastic cover that
prevents access to the cabling and to the Reset and Reload
buttons.
NOTE:
You cannot connect an RS-232 cable to the AP-8 when a security
cover is installed.
a. Slide the hinge end of the security cover into the hole on the
rear panel of the AP-8 to the left of the connectors.
b. Use two screws to screw the right side of the security cover to
the RS-232 screw holes on the rear panel of the AP-8.
5. Conduct a site survey to determine the best location for your
device. Once you have chosen a final location for your unit, mount
the AP-8 on a ceiling or a wall as follows:

Mount the AP-8 to a Ceiling

a. Attach the mounting plate to the bottom of the AP-8 by lining
up the keyholes and snapping it into place.
b. Snap the tabs onto the ceiling T-bar. Rotate the AP-8 until it
snaps on to the T-bar.
2-12 Avaya Wireless AP-8 User's Guide