Icom IC-12GAT Instruction Manual page 5

FEATURES 2. m
B PROGRAMMED SCAN AND The Programmed Scan function scans all fre-
MEMORY SCAN | quencies between 2 programmable scan edges.
The Memory Scan function scans all Memory
Channels in succession. Use the Memory Channel
Skip function to skip channels in a Memory
Scan.
R SOUELCH MONITOR Opens the squelch and the Tone Squelch. When
working a repeater, push this switch to monitor
the repeater input frequency.
ll 20 MEMORY CHANNELS Each Memory Channel stores an operating fre-
quency, a tone frequency, a repeater offset fre-
quency, the offset direction, and the Tone Squelch
ON/OFF.
B CALL CHANNEL The Call Channel is a separate Memory Channel
(IC-12GAT only) which provides easy access to your most often
used frequency and stores information as a
Memory Channel does.
R SPLASH RESISTANT Rubber gaskets ensure that water splashed on the
transceiver does not penetrate the casing.
NM POCKET BEEP When the UT-40 TONE SQUELCH UNIT (sold
(IC-12GAT only) separately) is installed, the transceiver functions as
a pager. When the frequency of a received tone
equals the tone frequency you have selected, the
speaker emits a 30sec. alarm and "SQL" flashes.
iM POWER SAVER Keeps battery current drain to only 20mA. When
operating Packet, turn OFF the power saver in an
instant.
B RECEIVER RIT shifts the receive frequency by up to +5kHz
INCREMENTAL in 7 steps of 800Hz. Use RIT to tune in an
TUNING (RIT) off-frequency signal.
B VARIABLE CRYSTAL VXO shifts the receive and transmit frequency by
OSCILLATOR (VXO) up to £bkHz in 7 steps of 800Hz.
É